Train Tech SS2R 2 AspectξDistant Sensor SignalξRight Handed Feather (Yell & Green LED's)
Sensor Signals - Fully Assembled Automatic Signalling - Now you can add automatic signalling to your layout in seconds with the new Sensor Signals.
äó¢ Feathers can be controlled by a Mimic switch or by DCC
äó¢ŒæLeft Hand Feather and äóÖTheatreäó» Route indicatorsŒæalso available.
Signals with built in sensors which operate automatically on their own. Can be linked to other Sensor Signals & Mimic Switches using a single wire. On DCC they slide into the track like a power clip or can be wired to work on analogue DC* or digital DCC.ξ
Sensor signals work exactly like the real railway - signals automatically turn red when a train enters a block section to prevent other trains from entering the same block and preceding signals automatically change accordingly.
A sensor is built into every signal so there is no wiring or extra circuit boards etc. Just clip the signal into your track or wire for fully automatic 2, 3 or 4 aspect signalling which works just like the real railway!ξ
Quick and easy installation - everything is built into the signal!
äó¢ Signal senses train and changes signal until train safely past.
äó¢ Realistic lights fade between changes.
äó¢ Can link through socket to Mimic light using a single wire to show occupancy & position on a control panel (see Mimic switches)
äó¢ Links to other Sensor Signals with a single wire for fully automatic block signalling!
äó¢ Fully built ready to use signal with all electronics including sensor built into the signal & base- no other circuits or wires needed!
äó¢ Automatic function can be overidden by a Mimic switch or a DCC command.
äó¢ On Digital DCC - just slide in or wire straight into track for automatic or DCC control.Œæ On Analogue DC* - wire to a regular 12-16V DC supply
äó¢ Assembled & tested and come complete with a Detailing kit including - ladder, handrail, phone etc
äó¢ Fully assembled DCC LED Signals and Signal Kits are also available
* To use DC it is recommended the fingers are removed and the signal wired to a separate 12V supply.ξ This will enable continuous operation.ξ See user instructions supplied with the signal for full details.ξ
