| Basic CV programming from DR50004 August 2022 | Admin Configuring CV’s via Digikeijs DR5000
Connect the DR5000 USB port to a PC via the supplied cable. Connect test track to the Prog Track output on the DR5000 Open the DR5000 config tool
Select the Prog track area on the DR5000 interface The following window will appear Select Service as the Mode Place the Loco on the service track The address field is the Locomotive address, click on the read button to identify the current loco address To change the address, enter the required address in the text area and select the write button You can now read and write your CV numbers and values to the loco by entering the CV number and the value
Resetting Decoder to default settings By entering the values as shown below, the decoder can be set to its default settings. After the reset is carried out it is advisable to check that the default settings have been applied by reading the CV values once again. END
|